Table of Contents
Advertisement
Appendix
Troubleshooting
Refer to the following chart if the air conditioner operates abnormally. This may save time and unnecessary expenses.
PROBLEM
The air conditioner does not
operate immediately after it has
been restarted.
The air conditioner does not work
at all.
The temperature does not change.
The cool (warm) air does not come
out of the air conditioner.
The fan speed does not change.
Timer function does not set.
Odors permeate in the room during
operation.
The air conditioner makes a
bubbling sound.
Water is dripping from the air flow
blades.
12
Big Duct_IBIM_E_33766-3.indd 12
• Because of the protective mechanism, the appliance does not start operating
immediately to keep the unit from overloading.
The air conditioner will start in 3 minutes.
• Check that the power plug is properly connected. Insert the power plug into the
wall socket correctly.
• Check if the circuit breaker is switched off.
• Check if there is a power failure.
• Check your fuse. Make sure it is not blown out.
• Check if you selected Fan mode.
Press the Mode button on the remote control to select another mode.
• Check if the set temperature is higher (lower) than the current temperature. Press
the Temperature button on the remote control to change the set temperature.
Press the Temperature button to decrease or increase the temperature.
• Check if the air filter is blocked by dirt. Clean the air filter every two weeks.
• Check if the air conditioner has just been turned on. If so, wait 3 minutes. Cool air
does not come out to protect the compressor of the outdoor unit.
• Check if the air conditioner is installed in a place with a direct exposure to
sunlight. Hang curtains on windows to boost cooling efficiency.
• Check if the cover or any obstacle is not near the outdoor unit.
• Check if the refrigerant pipe is too long.
• Check if the air conditioner is only available in Cool mode.
• Check if the remote control is only available for cooling model.
• Check if you selected Auto or Dry mode.
The air conditioner automatically adjusts the fan speed to Auto in Auto/Dry
mode.
• Check if you press the Power button on the remote control after you have set
the time.
• Check if the appliance is running in a smoky area or if there is a smell entering
from outside. Operate the air conditioner in Fan mode or open the windows to
air out the room.
• A bubbling sound may be heard when the refrigerant is circulating through the
compressor. Let the air conditioner operate in a selected mode.
• When you press the Power button on the remote control, noise may be heard
from the drain pump inside the air conditioner.
• Check if the air conditioner has been cooling for an extended period of time with
the air flow blades pointed downwards. Condensation may generate due to the
difference in temperature.
SOLUTION
2012-01-13 오후 9:40:24
Advertisement
Table of Contents
