Table of Contents
Advertisement
Electromagnetic fields (EMF)
This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled
properly and according to the instructions in this user manual, the appliance is safe to use based on
scientific evidence available today.
Preparing for use
hose
1
To connect the hose, push it into the appliance and turn it clockwise (Fig. ).
To disconnect the hose, turn it anticlockwise and pull it out of the appliance.
To connect the tubes to each other and to the handgrip of the hose, insert the narrow
section into the wider section while turning a little. The tube with the clip is the lower
tube (Fig. ).
You can connect the accessories in the same way.
Disconnect the accessories and tubes by pulling them and turning them a little.
Telescopic tube (specific types only)
1
Adjust the tube to the length you find most comfortable during vacuum cleaning. (Fig. 4)
Combination nozzle
The combination nozzle can be used on either carpets (with the brush strips folded in) or hard
floors (with the brush strips folded out):
1
To clean hard floors, push the rocker switch on top of the combination nozzle with your
foot. The brush strips come out of the nozzle housing. (Fig. 5)
To clean carpets, push the rocker switch on the other side to make the brush strips
disappear into the housing. (Fig. 6)
Accessory clip
The accessory clip can simply be snapped onto the tube.
-
The crevice tool and the small nozzle (specific types only) can be snapped onto the clip (Fig. 7).
Using the appliance
Vacuuming
1
Pull the cord out of the appliance and put the mains plug in the wall socket.
Push the on/off button on top of the appliance with your foot to switch on the appliance.
-
You can carry the vacuum cleaner by the handle at the front of the appliance.
Adjusting suction power
You can adjust the suction power by means of:
-
the slide on the handgrip, or (Fig. 8)
-
the suction power knob (specific types only) (Fig. 9).
storage
1
Switch off appliance and remove the mains plug from the wall socket.
Press the cord rewind button to rewind the mains cord.
Put the appliance in upright position and attach the lower tube to the appliance by means of
the clip (Fig. 10).
English
Advertisement
Table of Contents
