Clock Set/Correction; Electric Heater Set - Hisense YXE-C02U Use And Installation Instructions

FUNCTION SET

CLOCK SET/CORRECTION

CLOCK SET
First time using and clock loss caused by unused for a
long time, setting clock is needed at first.
How to set:
1.
and all blinks after turning on
2.Press" "and" "to set the current day of the week
an current time.
3.Press "ENTER" to confirm. After setting is completed,
and stop blink.
CLOCK CORRECTION
When the clock is different with the standard time，
need for clock correction.
How to set:
1.Hold down"TIMER/CLOCK" button for 3 seconds
under complete shutoff state,enter clock correct setting.
2.Adjust the clock following the sequence below:
DAY
①
Firstly the day of the week indicator blinks, and press and
to select the desired day, for example,(Thursday)
press "ENTER" to confirm .
hen
②T
blinks,press"
when reaches the desired time press enter to confirm.
③Then need seconds setting,setting method is the same as hours setting.
3.After making the appropriate settings,the buzzer beeps 4 times indicating
clock setting has been changed.
NOTE
：
1.CLOCK CORRECTION should be set under complete shutoff state.
2.Complete Shutoff:When turning on,hold down "ON/OFF"button for 3 seconds will enter complete shutoff state.
Temporary Shutoff:When turning on,press "ON/OFF"button will turn to shutoff state.
Shut off state in this manual all means temporary shutoff state.
3.After the wire remote controller get into the access of central control system its clock will be the same with the
central controller.

Electric heater set

When the appliance is turning on or turning off also with timer
set,press"ADD.FUNC."can manually select electric heater on
/off .Electric heater function changes in the following sequence:
After manually set the electric heater on, the indicator
according to the actual state after 5 minutes(electric heater may not start as the internal
control condition is not satisfied).
After manually set electric heater off, the indicator
off immediately.
NOTE
：
1.It is only valid for models with electric heater, and only can be selected under heating mode.
2.If not manually set electric heater function, it will auto turn on/off according to the outer temperature ,etc.
3.After mode changing, power failure, turning on/off ,manually electric heater function set will be cleared.
.
HOUR
" (increase) or "
BLANK
Electric Heater ON Electric Heater OFF
9
1
MINUTE
,
" (decrease)to select,
will lights on, and will light on/off
will goes off, and the electric heater turn
indicator of day
clock
of week
2
3
2