Safety Summary - Hisense YXE-C02U Use And Installation Instructions

Safety precautions

3. Safety summary

●Do not install the appliance by the user. Ask the dealer or authorized company to install it.
Improper installation could cause damage by fire or electric shock .
●Perform the installation correctly referring to the installation manual.
Incorrect installation could cause a personal injury due to fire, electric shock.
●Do not splash water on the appliance and do not touch it with wet hand .
These products are equipped with electrical components , splashing water could cause serious
electric shock or short-circuit.
●Must not touch or regulate safety device in the appliance.Otherwise serious accident may occur.
●Please be sure to cut off the main power supply before opening the panel to repair.
●Please use specify specifications cable.Firmly connected to the connection part of wire terminals ,
and avoid being shell. Do not apply wire stress to these parts. Otherwise it will cause fever or
fire,etc.
●Install the appliance on the base that can support its weight. Otherwise it may cause injury in the event
the appliance falls off the base.
●Connect with the electric supply after installation and check electric leakage.
● Avoid the following places for installation where appliance trouble is liable to occur.
Places with an oily ambient.
·
Places where sulfide gas occurs such as hot springs.
·
Places with a flammable gas.
·
Salty places such as seaside.
·
Places with high temperature or flames,may lead to heat or fire.
·
·Where there is high-frequency or wireless equipment. It will cause interference .
Moisture or water flooding place. Once the water enters the inside of the remote control,
electric shock or electronic parts failure may occur.
●Do not install the appliance or connect the wires before reading the manual.
●Prohibit within the scope of 1 meter of the appliance using spray,such as pesticides,
paint, hair gel or other toxic gases.
●If the ELB(Electric Leakage Break) or fuse trouble is liable to occur,please consult local service shop.
●Installation and wring work should be perform according to the manual.
Otherwise electric shock or fire may occur.
●Do not ride or place the object that with no relation with the appliance on the unit.
●Protect the wires, electrical parts, etc. from rats or other small animals. If not protected, rats may gnaw
at unprotected parts and at the worst, a fire will occur.
●Firmly connect wires. Excessive force may cause fire.
●If the electric box or fuse break is liable to occur, please consult local service shop.
●Install indoor unit,outdoor unit ,wire remote controller or cables at least 3 meters away from high-
frequency source (such as medical appliance) .
● Do not trample products or place anything on it.
●Choose a place as described below to install wire remote controller in order to let TEM. sensor work normally.
A.A place where average temperature in the room can be detected.
B.A place where is not exposed to direct sunlight.
C.Avoid extremely hot or cold locations.
●Do not play with the wire remote controller.
！
！
！
2