Zanussi ZOG10311XK User Manual page 15

• To clean the door gasket, refer to the
general information about cleaning.
Removing the shelf supports
To clean the oven, remove the shelf supports.
1. Pull the front of the shelf support away from
the side wall.
2. Pull the rear end of the shelf support away
from the side wall and remove it.
1
Install the shelf supports in the opposite
sequence.
Cleaning the oven door
The oven door has two glass panels. You can
remove the oven door and the internal glass
panel to clean it.
The oven door can close if you try to
remove the internal glass panel
before you remove the oven door.
CAUTION!
Do not use the appliance without the
internal glass panel.
Open the door fully
1
and hold the two
door hinges.
www.zanussi.com
2
Lift and turn the
2
levers on the two
hinges.
Close the oven door
3
halfway to the first
opening position.
Then pull forward and
remove the door from
its seat.
2
B
Hold the door trim (B) on the top edge of the
door at the two sides and push inwards to
release the clip seal. Pull the door trim to the
front to remove it.
Hold the door glass panel by its top edge and
carefully pull it out. Make sure the glass slides
out of the supports completely.
Clean the glass panel with water and soap. Dry
the glass panel carefully.
When the cleaning is completed, install the
glass panel and the oven door. Do the above
steps in the opposite sequence.
The screen-printing zone must face the inner
side of the door. Make sure that after the
installation the surface of the glass panel frame
on the screen-printing zones is not rough when
you touch it.
Put the door on a soft
4
cloth on a stable
surface.
1
15