Problems And Solutions; Operation Problems; No Image Appears On The Screen; "An Unknown Usb Device Has Been Connected. " Is Displayed - Epson ELPDC07 User Manual

Problems and Solutions

Operation Problems

No image appears on the screen

• Check that the USB cable is connected properly and that the power
indicator is on.
• Select the correct source on your projector. The source refers to the
port on the projector to which you have connected the cable.

"An unknown USB device has been connected. " is displayed.

When you connect to some Epson projectors, the following message may be
displayed: "An unknown USB device has been connected. Remove the USB
device." Set the Mic switch on the document camera to Off, and then
connect to the projector again. (Note that setting the Mic switch to Off
disables input from the internal microphone.)
"Top/Side/Rear" p.8
s

Image Quality Problems

The image is fuzzy or out of focus

In the following situations, the auto focus function may not work correctly:
• If the document is less than 10 cm (4 inches) away from the camera
lens.
• If the contrast for the document is too low
• If the document has detailed patterns, such as horizontal stripes and
checkered patterns
• If the surroundings are dark
• If the document has a bright background
Check the projection environment, and then press the [Focus] button
again.

Image colors are incorrect

If the projected image colors are incorrect, press and hold the [Focus]
button for approximately five seconds to adjust the white balance for the
image and environment. To restore the white balance to the previous
setting, press and hold the [Focus] button again.
20