Panasonic DP-MB311EU Operating Instructions Manual page 27

Important notice
When installing using a USB cable connection, a
message may appear during the software installation.
This is normal and the software will not cause any
difficulties with your operating system. You can
continue the installation with no problem. This kind of
message is displayed:
R For Windows XP users
"The software you are installing for this hardware
has not passed Windows Logo testing to verify its
compatibility with Windows XP."
R For Windows Vista/Windows 7/Windows 8
users
"Would you like to install this device software?"
3.9.3 Wireless LAN connection
Note:
R It is recommended to connect the unit to the wireless
network before installation.
For information about configuring wireless LAN
settings, please refer to "3.7 Wireless LAN
settings", page 24.
If the unit has already been connected to the wireless
network
1. [Easy Installation (Wireless LAN)]
2. Select [Already set up wireless LAN].
R The installation will start automatically.
3. When the setup program starts, follow the on-screen
instructions.
R Easy Print Utility (page 39) and Device Monitor
(page 97) will also be installed.
4. The [Select a Network Device] dialogue box
appears.
1. Check [Select from the search list] and select
the unit from the list.
R If the name of the desired unit is not displayed
on the list, and the IP address for the unit has
been assigned, check [Direct input] and
enter the IP address.
2. [Next]
R You can change the name of the unit if
necessary.
3. Click [Install], then follow the on-screen
instructions.
R The files will be copied to your computer.
If the unit has not been connected to the wireless
network yet
1. [Easy Installation (Wireless LAN)]
2. Select [Not yet set up wireless LAN].
R The installation will start automatically.
Important:
R The USB cable is required for configuring
wireless LAN settings. Wireless LAN settings
can be configured by using the wireless LAN
setting tool after installing it via USB
connection.
3. When the setup program starts, follow the on-screen
instructions.
R Easy Print Utility (page 39) and Device Monitor
(page 97) will also be installed.
4. The [Connect Device] dialogue box appears.
1. Connect the unit to a computer with the USB
cable, then click [Next].
R If the unit is connected to your computer, the
model name will be automatically detected.
R You can change the name of the unit if
necessary.
2. Click [Install], then follow the on-screen
instructions.
R The files will be copied to your computer.
5. When Wireless LAN Setting tool is launched, follow
the on-screen instructions to configure the wireless
LAN settings.
3.9.4 Other information
To view or install the operating instructions data
1. Start Windows and insert the supplied CD-ROM into
your CD-ROM drive.
2. Click [Operating Instructions], then follow the
on-screen instructions to view or install the operating
instructions in PDF format.
® ®
R Adobe Reader
instructions.
Note:
R If you install the operating instructions, you can view
it anytime by clicking [Help] on the Multi-Function
Station launcher.
To use another unit with the computer
You need to add the printer driver for each unit, as
follows.
1. Start Windows and insert the supplied CD-ROM into
your CD-ROM drive.
2. [Modify] A [Add Driver] A [Add Multi-Function
Station Driver]. Then follow the on-screen
instructions.
Note:
R You cannot connect more than one unit to the same
computer at the same time (USB connection only).
To modify the software (To add or uninstall each
component)
You can select the components to install or uninstall
anytime after the installation.
You must be logged in as an administrator in order to
modify Multi-Function Station.
1. Start Windows and insert the supplied CD-ROM into
your CD-ROM drive.
3. Preparation
is required to view the operating
27