Call Setup - Siemens C75 User Manual

right page (89) of C75 FCC, us-en FUG am, (09.06.2005, 08:40)

Call setup

Settings
¢
C ¢
Hide ID
When you make a call, your phone
number can be displayed on the re-
cipient's display (depending on the
service providers).
To suppress this display, you can en-
able the "Hide ID" mode for all subse-
quent calls or just for the next call.
You may need to register separately
with your service provider for these
functions.
Call waiting
If you are registered for this service,
you can check whether it is set and
you can activate/deactivate it.
Divert
You can specify the conditions under
which calls should be diverted to
your mailbox or other numbers.
Status check
You can check the current divert sta-
tus for all conditions. After a short
pause, the current situation is trans-
mitted by the network and
displayed.
¢
Call setup
T
Select function.
Condition set.
Ö
Not set.
Õ
Display if status is un-
Ô
known (e.g. with a new
SIM card).
b
Clear all
All set diversions are cleared.
Set up call divert (example)
The most common condition for call
divert is, for example:
Unanswered
Select Unanswered. (In-
cludes the conditions
I
reachable,
see below)
b
Confirm.
C
Select.
Set
Confirm.
C
Select or enter the phone
/
Ï J
number to which the calls
are to be diverted.
§Mailbox§
box phonenumbers, or
enter them if necessary.
Confirm. After a short
§OK§
pause, the setting is con-
firmed by the network.
Settings 89
b
b
Not
No reply, Busy,
Use existing mail-