Operation: Receiver Collar; Operation: Syncing Remote Transmitter And Receiver Collar; Operation: Testing Training Collar - ObeDog Stride Manual

Receiver Collar
1. Once Turn ON, a beep will sound to notify you it is active.
2. The LED will blink once every 5 seconds to signal it is active.
3. The Receiver Collar enters Standby Mode if no activity is detected for 20 second. Any movement detected will
automatically Wake it up.
4. When a recharge is required, the receiver collar will beep for 20 seconds.
Note: When you turn the receiver ON, if the receiver collar beeps for 20 seconds, you need to recharge it before using.
Syncing Remote Transmitter and Receiver Collar
1. Turn on the Remote Transmitter by holding the Mode Button for 5 seconds.
2. Select channel 1 or 2 to sync each Receiver Collar.
3. Press the RESET button on the Receiver to enter encoding mode for 5 seconds.
4. When you hear a beep from the Receiver Collar, press Command Button on the Remote Transmitter immediately.
5. Once synced properly, you will hear a beep to confirm successful pairing.
Note: If you fail to hear a second beep confirming sync from the Receiver Collar, you need to re-sync it. Repeat Steps
3-5 above.
Testing
Static Shock Test
 Secure the included Test Bulb Kit and wind its metal wire on the Receiver Collar's Contact Points.
 Press Mode Button on the Remote Transmitter and select Shock Mode.
 Be sure the level setting is not set to zero.
 Press Command Button and the test bulb will light up indicating the shock feature works.
Vibration Test
 Press Mode Button on the Remote Transmitter and select Vibration Mode.
 Be sure the level setting is not set to zero.
 Press Command Button, the Receiver will vibrate indicating the Vibration feature works.
ObeDog Stride / Stride Dual Training Collar: 3.7V 180mAh Lip
Operation
8 | P a g e