General Tips And Training Guide; Troubleshooting; Regular Maintenance - ObeDog Stride Manual

General Tips and Training Guide

 The ObeDog Stride / Stride Dual Receiver Collar is not designed to be worn constantly. We recommend the
Collar not be worn for more than 12 hours out of a 24-hour period.
 Most dogs will feel uncomfortable at first when wearing the collar for the first time. Don't use any commands until
your dog has gotten used to the collar.
 Eliminate one improper behavior or teach one obedience command at a time. If you move too quickly with
training, your dog may become confused.
 Be consistent. Give your dog the same stimulation for each improper behavior.
 We suggest you use Vibration Stimulation before starting the Static Shock Stimulation. When you follow this
training method, your dog will learn that Static Shock Stimulation might come after Vibration
 Stimulation. Hence, the Vibration Stimulation alone can effectively cure improper behaviors of your dog without
using Static Shock Stimulation.
 Do not over-correct. Use as little stimulation as possible to train your dog.
 Setting up a scenario in a training session can dramatically improve your chances of success.
 Should your dog reacts to the training by hiding or reacting fearfully, redirect his attention to a simple and
appropriate command such as "Sit" to calm him down.

Troubleshooting

My ObeDog Stride / Stride Dual System is not working?
 Charge the Transmitter and Receiver Collar for approximately 30 – 45 minutes individually first.
 Make sure the Transmitter is turned ON by holding the Mode Button for 5 seconds.
 Check the levels of Vibration or Static Shock stimulation.
 Intensity levels has to be higher than "0" in order for Vibration and Static Shock Stimulation to work.
 Make sure the Receiver Collar has enough power to operate.
 Restart the Receiver collar by pressing the ON/OFF button.
 Make sure the Contact Points are placed snugly against your pet's skin.
 If all of above does not work, you can re-sync the remote Transmitter and Receiver Collar. (Refer "Syncing
Remote Transmitter and Receiver Collar" of Setup/Operation Guide)
My ObeDog Remote Transmitter does not work
 Check if Transmitter is low on battery, the symbol
 Hold the Remote Transmitter for 5 seconds to turn on it.
 Remote Transmitter will automatically goes into Standby Mode if no instruction is detected within 10 seconds.
Press any button except LED Light button to re-activate the Remote Transmitter.
My ObeDog Receiver Collar starts to beep for 20 seconds when I turn it on
 The Receiver Collar will beep for 20 seconds on Low battery status. Charge it for approximately 30 – 45 minutes
and the beeping sound will go away when it's fully charged.

Regular Maintenance

 Check Contact Points for tightness weekly
 Clean Contact Points with alcohol weekly
 Check your dog's neck for irritation weekly
 Charge both the Transmitter and Receiver collar as least once a month especially when it's not in use to prevent
damage to the rechargeable batteries.
General Tips & Training Guide
will show up on the right down side of LCD screen.
10 | P a g e