3Com 4200G Getting Started Manual page 24

24 C 2: I
HAPTER NSTALLING THE
S
WITCH
Figure 6 Positions for mounting the screw on the switch
Follow the steps below to mount the rear bracket:
1 Use screws to fix the rear bracket to the rear mount angle.
2 Determine the position for mounting the screw on the switch
according to the position of the mount angle.
3 Mount the screw to the switch and make sure the screw and the rear
bracket are closely connected.
Figure 7 Installation completed 1
Rear bracket Rear bracket
Screw 1: Fix the rear bracket to the mount
angle.
Three positions for screw mounting Three positions for screw mounting
Screw 2 Screw 2
Screw 2 is mounted to the switch.
Screw 1 Screw 1
Rear mount Rear mount
angle angle