Connection And Operation - Kensence S-Mix-Pro 80*80 Operation Manual

3.Connection and operation

Note: do not operate on the matrix within 2 minutes of the start of the matrix!!!
1.Connect signal source such as blu-ray player、game controller、A/V receiver、cables、
satellite receiver etc. to the HDMI input port of the matrix.
2.Connect the output port of the matrix to HD display or HD projector with HDMI input
port.Notice:It's better to use High-Speed HDMI Cable when the transmission distance is
too long.
3.Firstly power on the signal source，then the matrix(with power supply)，finally devices
connected to the output port .
4.Plug in power to each device in the same order .
5.If all devices are connected properly,every display device should display the specified
signal to make sure the devices are normal.If one of the displays failed to receive signal
correctly,enter the menu of display,adjust the resolution from MIN to MAX until the signal
is displayed normally.A 24 Hz vertical refresh rate may work better than 60 Hz or higher.
The following diagram is S-Mix-Pro matrix switching system application:
5