Table of Contents
Advertisement
3) change IP: when serial port or ethernet control connection is normal, enter the IP
changed in the network address in configuration bar , click Save to change IP.
4 Buzzer on / off:when serial port or network port control connection is normal, click
"open" button next to the buzzer can close or open it.
5)Open / close video backup: when serial port or network port control connection is
normal,click the "open" button next to the video backup can close or open it.
6.4 Video switching operation
Click "SWITCH" to the switch interface, first select the input port, the selected input port
will be displayed in the interface in the lower left corner, such as figure 6.4.1 selected input
signal "18", the output can select multiple ports (selected port will be orange) as shown in
the following selected "3, 4, 5, 6. After selection, click "APPLY" button, then click "TAKE"
to achieve the corresponding switching operation.
Through the above steps, we can switch inputted signal "18" to the output port "3, 4, 5, 6"
to output.
Figure 6.4.1 SWITCH interface
18
Advertisement
Table of Contents
