Table of Contents
Advertisement
selected more, as shown in Figure 6.2.2 it selected "06, 07, 08, 12"output signal, and then
click "Apply ", and then click "Take" to complete the switch. As mentioned above, the "08"
input signal can be switched to 08, 06,, 08, 12,, output signal.
When operation, click "UnPickALL (choose all options)", you can select all the
output ports, click "PickALL (cancel all options), click" Preview "the current state of input
and output, click" Undo "to undo the application.
Figure 6.2.2 SWITCH interface
3.SCENE interface：As shown in figure 6.2.3, the interface can call all the scene saved
before, select the 01~13 to call the scene, after selection, the screen will display the
configuration of the current scene, click "Load" to call the selected scene (00 is the current
input and output status of matrix, can not be selected), as shown below in the "Scene 2",
click "Load" to call.
12
Advertisement
Table of Contents
