SAB JOLLY PRESTIGE 1GR User Manual page 8

SV JOLLY.pdf 1 17/10/2014 4:52 pm
Start up
The espresso machine Jolly is to be installed to comply with the applicable federal, state
or local plumbing codes having jurisdiction exclusively by authorised technical service.
Open the water tap and switch on the main electrical switch.
Turn the on/off switch (fi g. 1,4) from position 0 to position 1.
At the fi rst start up the boiler is empty and therefore the automatic water refi ll system starts.
Note: After approx 180" the autorefi ll function stops. In case the boiler is not completely fi lled in, the
leds on the touchpad fl ash. In this case turn again the on/off switch (fi g.1.4) on 0 and then 1 to begin
again the fi lling.
Turn the on/off switch on position 2. to begin the heating.
Wait till the boiler pressure has reached the working pressure (0.9 bar approx). You can check it on
the gauge (fi g. 1,8).
Open the steam tap (fi g. 1,1) for some seconds and then close it. This operation avoids milk sucking in
the boiler. As the above operation causes pressure reduction in the boiler, wait till the working pressure
is reached again.
Your machine is now ready to work.
Operation
Insert the lower fi lter in the fi lter holder
with 1 spout to prepare 1 cup of espresso.
Fill with 6/7 gr. appr. of grinded coffee and
tamp it.
Insert the higher fi lter in the fi lter holder
with 2 spouts to prepare 2 cups of
espresso.
Fill with 12/14 gr. appr. of grinded coffee
and tamp it.
To begin the erogation of the espresso, insert the fi lter holder (fi g.1,7) into the coffee brewing group
(Fig.1,6).
Put the cups beneath the spouts and press the key corresponding to the wished selection (only for
automatic version).
User Manual - Jolly Prestige
2014 – Page 7
Specifications subject to change without notice