Hollywog WiTouch Pro TENS User Manual page 4

Connecting the WiTouch Pro Device with
your Smartphone for the First Time
1. Using the provided screwdriver, remove the
back cover from the WiTouch Pro device.
2. Insert the two (2) AAA batteries into the
device, noting the correct (+) and (-) polarity.
3. Replace the back cover on the device.
4. Switch on Bluetooth
5. Press and hold the ON/OFF button on your WiTouch Pro device for one (1) second. The LED
will begin flashing slowly to indicate the device is ready for use and in standby mode.
6. On your WiTouch Pro device, press and hold the (+) and (-) buttons simultaneously for 3 seconds
to enter pairing mode. The LED will appear solid green.
7. Open the WiTouch Pro app on your smartphone and the app automatically searches for your device.
a. Your Device Has Been Paired: The WiTouch Pro app and device automatically connect
and no further action is required; the app will display the home screen.
b. Device Not Found: WiTouch Pro app will provide instructions to repeat the device search
and pairing process. Press "OK" on the app screen to begin the device search again.
Note: The pairing process will automatically continue to prompt you with instructions until
pairing is successful or the process is discontinued by closing the app. The 'Device Not Found'
screen will appear if the device is OFF or too far away from your smartphone. Some smartphones
require a manual pairing process, and all on screen instructions should be followed.
Ensure your device is in pairing mode per instruction 6.
8. Once the initial pairing of your WiTouch Pro device and smartphone is complete, pairing is
not required again unless the app is deleted from your smartphone or the device is replaced.
The WiTouch Pro app and device will automatically connect when the app is started and the
device is turned ON.
2
on your smartphone.
®
1
3