Sharp MX-4111N Technical Handy Manual page 9

SHARP
PRINT IMAGE POSITION & MAGNIFICATION
Automatic Adjustment:-
Sim 50-28
Manual Adjustment:-
Sim 50-10
Sim 50-10
Sim 50-05
IMAGE SKEW & COLOUR REGISTRATION
Sim 61-04
Sim 50-22
COLOUR CALIBRATION
Sim 46-74
COPY IMAGE QUALITY
Check Image Quality (Copy Mode) – Density, Magnification, Lead Edge & Void.
If NG, perform the following adjustments as required:-
Manual Adjustment (Magnification, Lead Edge, Void, Off Centre etc):-
PRINT IMAGE QUALITY
Check Image Quality (Print Mode) – Density.
Sim 64-05
Sim 64-06
BK MAG ADJ (Main Scan Mag).
SETUP/PRINT ADJ (Lead, Offset or All).
BK MAG (inside dimension) to 240mm.
Image Off Centre Adjustment.
Printer Lead Edge & Void Adjust.
Image Skew Adjustment (Black):-
Colour Registration/Skew & OPC Drum Phase Adjustment:-
Check/Adjust SKEW (CMY) so value is Close to 0 as possible
(Result=OK)
Engine & Printer Colour Calibration:-
Sim 46-01 Copy Density Adjust. (Colour).
Sim 46-02 Copy Density Adjust. (B/W).
Sim 46-09 DSPF Copy Density Adjust.
Sim 50-28 OC ADJUST (Lead, Offset & Mag).
SPF ADJ:(Lead, Offset & Sub scan).
Sim 48-01 Magnification Adjustment (OC & SPF).
Sim 50-01 Lead/Rear Edge, Loss & Void Adjust.
Sim 50-12 OC & SPF Off Centre Adjust.
PCL Density Test Page.
PS Density Test Page [MX-PK11 only].
INITIAL SETUP
Select A3 Paper
Select FACTORY Mode.
9