Special Features; Remote Control Functions - JVC HR-J271MS Service Manual

www.freeservicemanuals.info
32
EN
Remote
Control
Functions
VCR
1
NUMBER "1"
4
7
1
2 3
2
5 6
8 9
4
0
OK
Digitized in Heiloo Netherland

SPECIAL FEATURES

Remote A/B Code Switching
The remote control is capable of controlling two JVC video
recorders independently; one set to respond to the remote
control's A code control signals and another set to respond to B
code control signals. The remote control is preset to send A
code signals because your video recorder is initially set to
respond to A code signals. You can easily modify your video
recorder to respond to B code signals.
REMOVE POWER SUPPLY
1
Unplug the mains power cord from the mains outlet.
SET REMOTE CONTROL
CODE
2
While holding down VCR on the remote control, press
the NUMBER key "2" and then press OK.
RE-SUPPLY POWER
3
Plug the mains power cord back into the mains outlet.
TURN THE RECORDER ON
4
Press on the remote control. The recorder will now
only respond to B code signals.
NOTE:
To set the recorder back to respond to A code signals, repeat the
same procedure as shown above except pressing NUMBER key
"1" instead of "2" in step 2.
4/5/2017