Upper Drum Assembly - JVC HR-J271MS Service Manual

www.freeservicemanuals.info

2.2.25 Upper Drum Assembly

1. How to remove
(1) Remove the stator assembly and rotor assembly.
(2) Loosen the screw of the collar assembly using a 1.5 mm
hexagonal wrench and remove the collar assembly. Also
remove the brush, spring and cap at one time.
(3) Remove the upper drum assembly and remove the
washer using tweezers.
Note:
• When replacement is required, control the up- down
movement of the brush. Never apply grease.
Collar
Spring assembly
Brush
Cap
Upper drum
assembly
Washer
Fig. 2-2-25a
2. How to install
(1) Clean the coil parts of the lower drum assembly and the
newly installed upper drum assembly with an air brush
in advance. (See Fig.2-2-25b.)
(2) Install a new washer and upper drum assembly on the
drum shaft. (See Fig.2-2-25a.)
Note:
• When replacing the upper drum assembly, replace it
the together with the washer.
(3) Install the cap to the upper drum assembly.
(4) Position the collar assembly as indicated in Fig.2-2-25c
while controlling its up- down movement.
(5) Secure the collar assembly in position with a hexagonal
wrench while pressing its top with the fingers.
(6) After installation, gently turn the upper drum assembly
with your hand to make sure that it turns normally. Then
install the brush and the spring.
(7) Install the rotor assembly and stator assembly according
to Fig 2-2-23a and 2-2-24a.
(8) When installation is complete, clean the upper drum as-
sembly and lower drum assembly and carry out the fol-
lowing adjustments.
• PB switching point adjustment
• Slow tracking adjustment
• Compatibility adjustment (Be sure to check for compat-
ibility for the EP (or LP) mode.)
2-15
1.5 mm
hexagonal wrench
Loosen
Shaft
Lower drum assembly
Digitized in Heiloo Netherland
Lower drum assembly
Coil parts
Upper drum assembly
Fig. 2-2-25b
Upper drum
assembly
Fig. 2-2-25c
Press
Collar
assembly
Fig. 2-2-25d
4/5/2017
Collar
assembly
Tighten