Initial Settings; Video Channel Set - JVC HR-J271MS Service Manual

www.freeservicemanuals.info
4
EN
Video
Channel Set
Video Channel (RF Output Channel) is the channel on
which your TV receives picture and sound signals from the
video recorder through the RF cable.
1
4
7
1
TEST SIGNAL
To view picture signals from the video recorder, set
your TV to the Video Channel.
PR +/–
2 3
2
5 6
8 9
4
0
PR +/–
OK
The channel on which the screen to
the left appear clearly in step 3 is
your Video Channel.
Digitized in Heiloo Netherland
If you have connected the video recorder to your TV
via the provided RF cable only (RF connection) – Go to
"With RF Connection" below.
If you have connected the video recorder to your TV
via both the provided RF cable and an AV cable (AV
connection) – Go to "With AV Connection" on next
page.
With RF Connection
IMPORTANT:
Before performing the following steps, make sure the
recorder's power is off and there is no cassette inserted in
the recorder.
ACCESS VIDEO CHANNEL
SET MODE
1
Hold down STOP/EJECT on the recorder until the
display panel shows the following.
SELECT TV SYSTEM
2
Press PR + or – to set appropriate TV system that
matches the system of TV being used (refer to the table
below).
1 : B/G 2 : D/K
Major Countries
New Zealand, Kuwait, U.A.E.,
Indonesia, Singapore, Thailand,
Malaysia, Iran, Saudi Arabia,
Egypt, Morocco, Lebanon, Iraq
China, Mongolia, Russia
Hong Kong
Australia
U.S.A., Japan, S. Korea, Taiwan
*
HR-J777MS only

INITIAL SETTINGS

3 : I 4 : H 5 : M*
TV System
B/G
D/K
I
H
M*
4/5/2017