Dodge Dakota 2008 Owner's Manual page 145

144 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
This can usually be found where the hanging antenna
wire is attached to the garage door opener motor (it is
NOT the button normally used to open & close the door).
1 — Garage Door Opener
2 — Training Button
6. Firmly press and release the "learn" or "training"
button. The name and color of the button may vary by
manufacturer.
NOTE: There are 30 seconds in which to initiate the next
step after the "Learn" button has been pressed.
7. Return to the vehicle and press the programmed
HomeLink button twice (holding the button for 2 sec-
onds each time). If the device is plugged in and activates,
programming is complete.
If the device does not activate, press the button a third
time (for 2 seconds) to complete the training.
If you are have any problems, or require assistance,
please call toll-free 1–800–355–3515 or, on the Internet at
www.HomeLink.com for information or assistance.
To program the remaining two HomeLink
repeat each step for each remaining button. DO NOT
erase the channels.
buttons,