Table of Contents
Advertisement
Trip computer - trip statistics*
Trip statistics from the trip computer can be
shown in the centre console's screen and pro-
vide a graphic overview of fuel and electricity
consumption.
Function
–
Open the menu system MY CAR (p. 115)
and select
Trip statistics
in order to see the
bar chart.
21
Trip statistics
Fuel and electricity consumption are shown in
separate graphs. Electricity consumption is "net"
consumption, i.e. energy consumed minus regen-
erated energy created during braking.
Each bar symbolises 1 km or 10 km driven dis-
tance, depending on the scale selected - the bar
The figure is schematic - layout may vary depending on car model or updated software.
21
at the far right shows the value for the current kil-
ometre or 10 km.
Using the TUNE control, the scale for the bars
can be changed between 1 km and 10 km - the
cursor on the far right changes position between
up and down in relation to the scale selected.
Settings
Different settings can be made for trip statistics
in the menu system MY CAR -
Trip statistics
•
Reset when vehicle has been off for
minimum 4h
- highlight the box by select-
ing ENTER and go back out of the menu by
selecting EXIT. With this option selected, all
statistics are deleted automatically after fin-
ishing driving and the car has been stationary
for more than 4 hours. Trip statistics start
again from zero the next time the engine is
started.
•
Start new trip
- ENTER is used to delete all
previous statistics, go back out of the menu
by selecting EXIT. If a new driving cycle shall
be started before 4 hours have elapsed then
the current period must first be deleted man-
ually with this option.
See also information on Eco guide (p. 73).
Related information
•
Trip computer (p. 116)
INSTRUMENTS AND CONTROLS
.
* Option/accessory, for more information, see Introduction.
121
Advertisement
Table of Contents
