Dynojet POWER COMMANDER V Installation Instructions Manual page 6

FIG.K
19-001 www.powercommander.com
18 Attach the ground wire from the PCV to the negative side of the battery
(Fig. K).
19 To get the full potential out the bike and PCV the stock O2 sensors need to be
disconnected from the wiring harness. Locate the O2 sensor in each exhaust
and follow the wire to the main wiring harness. Unplug the sensor from the
harness. The rear O2 sensor can be seen in Figure H.
20 Reinstall all bodywork.
2009 Victory 100" models PCV - 6