Control - Bender Mode; Control - Clock Mode; Control - Clock Rate - Roland SH101-M Owner's Manual

SH101-M
"Volume + Expression" mode
Both MIDI controllers "Volume" (CC #7) and „Expression" (CC #11) are used for control of
global loudness of the instrument.
The parameter value can be controlled by MIDI CC Nr. 49 – see chapter 5.1.2.2.
4.2.11. CONTROL - BENDER MODE (CC #50)
The parameter enables to choose the way for control of instrument's Bender left and right action
(the VCO and VCF depth sliders functionality remains unchanged as well as forward move of the
BENDER lever). Two modes are available: „Normal" (parameter value 0) or „MIDI" (parameter value
1).
"Normal" mode
Manual BENDER controller (lever) on instrument's panel works as normally and MIDI Pitch Bend
(Pitch Wheel) command is ignored.
"MIDI" mode
Manual BENDER controller (lever) on instrument's panel is disconnected and MIDI Pitch Bend
command (Pitch Wheel) is used instead of the SH-101 BENDER lever.
The parameter value can be controlled by MIDI CC Nr. 50 – see chapter 5.1.2.2.
4.2.12. CONTROL - CLOCK MODE (CC #51)
The parameter selects the source of synchronization clock pulses for arpeggiator and
sequencer. Four modes are available: "Normal" (parameter value 0), "Fix" (parameter value 1),
"MIDI" (parameter value 2) and "CC" (parameter value 3).
"Normal" mode
The arpeggiator and the sequencer are controlled by SH-101 internal tempo generator. "Control -
Clock Rate" parameter (see below) is ignored.
"Fixed" mode
The arpeggiator and the sequencer are controlled by interface clock generator. The tempo is set
by "Control - Clock Rate" parameter (see below).
"MIDI" mode
The rate of the synchronization clock pulses for the arpeggiator and the sequencer is derived
from the external MIDI Clock. MIDI Clock impulses can be divided - dividing ratio is selected by
"Control - Clock Rate" parameter (see below).
"CC" mode
The arpeggiator and the sequencer are controlled directly by CC #52. Every time the CC #52 is
received (any value), one clock pulse is generated.
This parameter is active only in the "Normal" working mode of the interface. The parameter value
can be controlled by MIDI CC Nr. 51 – see chapter 5.1.2.2.
Remark: EXT-CLK-IN connector on the SH-101's panel is functional in all modes. It is still possible to
use external clock signal if necessary.
4.2.13. CONTROL - CLOCK RATE (CC #52)
The parameter selects the rate of synchronization clock pulses for arpeggiator and sequencer if
"Fixed", "MIDI" or "CC" modes are active (see CTRL – Clock Mode section above). The parameter is
ignored in "Normal" mode.
"CTRL – Clock Rate" parameter values are 0 to 127 for "Fixed" and "MIDI" modes. Table 3
shows conversion rates of the parameter value to clock pulses. For "CC" mode, the parameter value is
insignificant.
No part of this publication may be reproduced in any form without the written permission of CHD Elektroservis.
MIDI Interface for Roland SH-101
Copyright © 2017 CHD Elektroservis. All rights reserved.
12
Model 8-438 ver. 1.0