L3 Nova Engineering NovaRoam MH902 User Manual page 14

•
Network. Destination network for the route that is being created. To enter a static route for a
device with an address of 192.168.200.1 and a subnet mask of 255.255.255.0, the Network
portion of the route entry should be 192.168.200.0.
•
Subnet Mask. Subnet mask for the destination network for which the route is being created.
•
Gateway. Next-hop gateway of the destination network for which the route is being created. The
gateway will be the IP address of the wireless interface of a NovaRoam.
•
Add. After entering the details of the static route, press the Add button to add the route to the
route table.
•
Cancel. Press the Cancel button to cancel the route creation process.
Adding a Static Default Gateway
Pressing the Add Default button will add an Add Default Gateway section to the Routing Tab.
•
Gateway. Enter the IP Address of the next-hop gateway that will act as the default gateway for
this NovaRoam. The gateway will be the IP address of the wireless interface of a NovaRoam.
•
Add. After entering the details of the default gateway, press the Add button to add the default
gateway to the route table.
•
Cancel. Press the Cancel button to cancel the default gateway creation process.
ARP Tab
The Address Resolution Protocol (ARP) is used to associate an IP address to a device's corresponding
MAC address. The ARP Tab, as shown in the following figure, is used to view existing ARP table entries,
as well as to add or delete ARP table entries. The following parameters can be configured:
•
Address Resolution Protocol Table. The Address Resolution Protocol table provides a list of
current ARP entries. An ARP entry consists of two pieces of information: an IP address and a
MAC address.
•
IP Address. To create a static ARP entry, enter the IP address of the device into the IP Address
field.
•
MAC Address. Enter the MAC address of the device into the MAC Address field.
•
Add. After entering the IP address and MAC address into the corresponding fields, press the Add
button to add the ARP entry to the Address Resolution Protocol table.
•
Delete. To delete an ARP entry from the table, first select the entry. Then press the delete button
to remove the entry from the Address Resolution Protocol table.