Servicing The Rear Suspension (Es-140 Only - Whyte ES-140 SCR Supplementary Service Manual

WHYTE Service Manual

6.0: SERVICING THE REAR SUSPENSION (eS-140 only)

6.1 Chain-stay removal & refit.
Tools required: Torx T25 Keys (2 off, 1 fitted to a 5Nm to 25Nm Torque Wrench)
To remove the chain-stays from the frame, using the Torx T25 keys, undo & remove both
of the M8 screws that secure the chain-stay pivot to the frame. The chain-stays may now
be removed, take care to retain the shield washers that sit between the bearings & the
frame.
To install the chain-stays, reverse the above procedure. The M8 screws must be tightened
to 16.1 Nm (Min) - 19.9 Nm (Max), 11.9 lbf/ft (Min) - 14.7 lbf/ft (Max).
To service the remainder of the rear suspension, please refer to the instructions detailed in
section 6.0 of the Whyte 2019 MTB Full suspension supplementary manual, available from
the following website: http://www.whyte.bike/support
7.0: TORQUE SETTINGS
IMPORTANT: For all torque settings, refer to the specific manufacturers information bun-
dled with this manual, or alternatively, refer to the specific manufacturers website for fur-
ther information.
Page 16
2019 Edition 1