Whyte ES-140 SCR Supplementary Service Manual page 10

Bolt-up Type: Fig.2
Tools Required:
(Note, refer to the seat-pin manufacturers instructions in conjunction with these notes).
To adjust the seat height, using the 5mm Allen key, undo the M6 bolt (5) just enough to allow the
seat-pin to slide freely up and down. Set the height to the desired level, and re-tighten the M6 bolt
(5) with the 5mm Allen Key just enough so as to prevent the seat-pin from slipping down and
twisting.
Item
1 QR Lever Cam Grub Screw
2
3 Whyte QR Lever
4
5 Whyte Main Frame
6 Whyte Seat Clamp Band
7 QR Adjuster Bobbin
8
9
Quick Release Lever Type: Fig.3
No tools required.
(Note, refer to the seat-pin manufacturers instructions in conjunction with these notes).
To Adjust the seat height with the QR Lever assembly fitted, simply undo the QR Lever (3) from
the Closed position to the Open position. Next adjust the height of the Seat Pin to the desired lev-
el, and close the QR lever (3) from the Open position to the Closed position. The QR closing force
can be adjusted by turning the QR Adjuster Bobbin (7) clockwise or anti-clockwise before closing
the QR Lever (3).
CAUTION! When adjusting the saddle height you MUST obey the Minimum insertion depth
requirement marked on the Seat Post.
Seat Clamp Service
3.3 Inter-Grip
Refer to the 2018 Whyte MTB Full Suspension Range Supplementary Service Manual, section 8.0,
for instructions on how to service the Inter-Grip seat clamp system. This User Manual may be
following website: http://www.whyte.bike/support.
downloaded from
Page 10
WHYTE Service Manual
5mm Allen Key
Description
QR Lever Cam
Plastic Shim
QR Shaft
T-Pad
Fig.3: Getta-Grip Seat Clamp: QR Lever
2019 Edition 1