Daikin EKHH2E200AAV3 Installation And User Manual page 28

To change the minutes:

Press and release the
time: the display will show "nn" followed by the two
numbers representing the minutes;

Press and release either the
within 15 seconds;

Press and release the
any operations for 15 seconds;
To exit the procedure:

Press and release the
shows the temperature established by parameter
P5 or do not carry out any operations for 60
seconds.
Alternatively:

Press and release the
To set operations within timeslots, it is necessary
to have carried out the settings relating to the
day and the real time beforehand.
8.1.3.15 Configuration parameter settings
To carry out the procedure:

Make sure that the keyboard is not locked
(paragraph 8.1.3.3) and that no other advanced
procedure is in progress;

Keep the and the
4 seconds: the display will show "PA" (password);

Press and release the

Press and release either the
within 15 seconds to set "-19" on the display;

Press and release the
any other operations for 15 seconds;

Keep the and the
4 seconds: the display will show the first
parameter "SP1".
To select a parameter:

Press and release either the
To change a parameter:

Press and release the

Press either the
increase or reduce the parameter value (within 15
seconds);

Press and release the
any operations for 15 seconds.
To exit the procedure:

Keep the and the
seconds or do not carry out any operations for 60
seconds (any changes will be saved).
Switch the equipment off and then back on again
to make the changes made to the parameters
effective.
Page 28
key while changing the
or the key
key or do not carry out
key until the display
key.
keys pressed for
key;
or the key
key or do not carry out
keys pressed for
or the key.
key;
or the key to either
key or do not carry out
keys pressed for 4
8.1.3.16 Restoring default factory settings
To carry out the procedure:

Ensure that the keyboard is not locked (paragraph
8.1.3.3) and that no other advanced procedure is
in progress;

Keep the and the
4 seconds: the display will show "PA" (password);

Press and release the

Press and release either the
within 15 seconds to set "149";

Press and release the
any operations for 15 seconds;

Keep the and the
the display will show "dEF";

Press and release the

Press and release either the
15 seconds to set "1";

Press and release the
any other operations for 15 seconds: the display
will show "dEF" flashing for 4 seconds, after which
the equipment will exit the procedure;

Disconnect the equipment from the mains power
supply.
To exit the procedure before its completion:

Keep the and the
4 seconds during the procedure (or rather before
setting "1": the restoring of default factory settings
will not be carried out).
8.1.3.17 TOTAL OF THE COMPRESSOR
OPERATING HOURS
8.1.3.17.1 General information
The equipment is capable of memorising up to 9,999
compressor operating hours, if the number of hours
exceeds "9,999" it flashes .
8.1.3.17.2 Display of compressor operating hours

Make sure that the keyboard is not locked
(paragraph 8.1.3.3) and that no other advanced
procedure is in progress;

Press and release the
show "Pb1";

Press and release either the
select "CH";

Press and release the
To exit the procedure:

Press and release the
any other operation for 60 seconds.
Alternatively:

Press and release the
keys pressed for
key;
or the key
key or do not carry out
pressed for 4 seconds:
key;
or the within
key or do not carry out
key pressed for
key: the display will
or the key to
key.
key or do not carry out
key.
Installation and user manual