Bosch GWH-635-ES User Manual page 8

Using the Remote Control
4.6 "Priority" function
Temperature cannot be
i
memorized or selected
using the control panel
buttons
second remote control
when hot water is in use
(e.g. during a shower)
since
function
automatically start up to
stop
modifying
temperature when hot
water is in use.
The equipment does not have a default
temperature setting and therefore has
no default "Priority"
"priority" will
automatically by the first user who
selects or memorises (on the remote
control or on the control panel) a
temperature for subsequent use (e.g. a
shower).
Then, when the hot water is used (e.g.
for a shower), the control panel display
and remote control/s display will show
the symbol "
The temperature may only be modified
using the same
memorized it (depending on whether
8
or even
the "Priority"
will
another user
the
function.The
be attributed
".
buttons
the control panel or the remote control
was used).
The "Priority" function ends:
• 5 minutes after the last use of the
hot water (return to basic set up).
a
• 2 minutes
memorizing the temperature if no hot
water
afterwards.
Acquiring "priority"
Any user can acquire "priority" for
subsequent use of hot water, as
follows:
B Move main switch to position I.
B Keep button
pressed.
B Select the required temperature.
B Press the "Program" button for 3
seconds
temperature, if required.
B Use the hot water within two
minutes of acquiring "priority.
i
4.7 Error Messages
that
This device has an error message
system.
after
is used
or button
to memorize
"Priority" cannot
acquired whilst the hot
water tap is open.
Any anomalies
6 720 606 990
selecting/
immediately
the
be
will be