Dmx Linking - Chauvet OVATION E-930VW Quick Reference Manual

Replacing the Fuse
1. Disconnect this product from power.
2. Using a Phillips #2 head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove blown fuse and replace with a good fuse of the same type and rating.
4. Screw the fuse holder cap back in place and reconnect power.

DMX Linking

The Ovation E-930VW will work with a DMX controller using a 3- or 5-pin DMX data connection. A DMX Primer is
available from www.chauvetprofessional.com.
DMX Connection
The Ovation E-930VW uses a 3- or 5-pin DMX data connection for its DMX personalities: 3Ch, 5Ch, 6Ch, 8Ch, 11Ch,
15Ch, and 17Ch. See the User Manual for information about connecting and configuring the product for DMX operation.
Master/Slave Connection
The Ovation E-930VW uses the DMX data connection for its Master/Slave mode. See the User Manual for information
about connect and configure the product for master/slave operation.
RDM (Remote Device Management)
Remote Device Management, or RDM, is a standard for allowing DMX-enabled devices to communicate bi-directionally
along existing DMX cabling. The Ovation E-930VW supports RDM protocol that allows feedback to monitor temperature
and changes to DMX Address, DMX Personality, Dimmer Mode, and LED Frequency menu options. Download the
User Manual from www.chauvetprofessional.com
Mounting
Before mounting this product, read the
mounting clamps are capable of supporting the weight of the product. For our CHAUVET Professional line of mounting
clamps, go to http://trusst.com/products.
Mounting Diagram
Mounting Clamp
Secure the safety cable
using the passageway on
the back of the product
Ovation E-930VW QRG Rev. 2
QUICK REFERENCE GUIDE
for more details.
Safety Notes. Use at least one mounting point per product. Make sure the
Safety Cable
Alternate Yoke Attachment
EN
2