Download Print this page

Advertisement

Quick Links

ASSEMBLY INSTRUCTIONS

WITH TELESCOPIC RODS
Prodotto da: Garlando srl Via Regione Piemonte, 5 Zona Ind. D1 15068 Pozzolo Formigaro (AL) ITALY

Advertisement

loading
Need help?

Need help?

Do you have a question about the Familiare and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Garlando Familiare

  • Page 1: Assembly Instructions

    ASSEMBLY INSTRUCTIONS WITH TELESCOPIC RODS Prodotto da: Garlando srl Via Regione Piemonte, 5 Zona Ind. D1 15068 Pozzolo Formigaro (AL) ITALY...
  • Page 2 If the table has a glass playfield, beware not to wet the card below, which could wave. Bars and bearings Garlando roller bearings do not require any lubrication. However, should you wish to furtherly improve their smoothness, employ a good quality silicone spray, such as Garlando’s proposal Slidy, which has a lubricating and protective double action.
  • Page 3 ASSEMBLY Important: keep away the children during the assembly. For safety reasons it is strongly recommended the football-table assembly by at least two adults. UNPACKING Lay the carton box on the floor. Note: the box label shows clearly the upper part. Cut the adhesive tapes and remove completely the carton top.
  • Page 4 Pag. 4...
  • Page 5 Ball entry fillers We suggest you to put on the ball entry fillers before the rod assembly. fig. 9 fig. 10 Insert manually the ball entry fillers (fig. 9), insert and tighten the screws into the holes (fig. 10) Do the same with the other ball entry filler.
  • Page 6 Rod position GB - The football-table is equipped with 4 rods for each team: Goalkeeper (1 player-rod): at the end of the playfield. Position A • Defence(2 player-rod): in front of the same colour goalkeeper. Position B • Mid-fielder (5 player-rod): in the middle of the playing field, in front of the 5-player rod of the •...
  • Page 7 Pag. 7...
  • Page 8: Roller Bearing

    BEWARE NEW MODEL Please follow these assembly instructions Roller bearing INT = Side of the bearing that must look towards the playfield Outside Bearing retainers Indside bearings retainers “A” “B” To match the two bearings, rest them on the bar while keeping them slanting so that the protruding part “A” is in front of the hollow part “B”, then bring them vertical by a slight pression.
  • Page 9 Pag. 9...