ROUTER PEDESTAL
You can attach the inverted back half of the case to a workbench with
screws through the holes (H) Fig. 30 In this configuration, storage for a
wrench (A) Fig. 31, spare collet (B), and 1/4" and1/2" router bits (C) is
available. You can cut out the center of the router parking pad (D) with a
sharp utility knife to allow for storage of the router with a bit installed.
To store the height adjustment handle, drill a 13/32" diameter hole at (E)
Fig. 31.
Both halves can be joined
together as shown in Fig. 32 to
provide storage for the router
and other parts on the work-
bench.
To avoid injury and/or damage to finished work, always allow
the motor to come to a COMPLETE STOP before putting the
tool down.
USING A ROUTER ACCESSORY TABLE
The router can be mounted to a router accessory table (not included).
For instructions on how to mount the router to the router accessory
table, refer to the accessory table instruction manual.
20
Fig. 32