Cisco GS7000 Installation And Configuration Manual page 52

Chapter 2 Installation
1 The first step depends on whether the fiber optic cable is factory installed or not.
IF...
fiber optic cable is
factory installed
fiber optic cable is not
installed
2 Select a left side (ports TP1 or TP2) or a right side (ports TP4 or TP5) fiber
connection port for use and remove its sealing plug.
3 Slip a length of heat shrink tubing over the MPO fiber cable connectors and past
the main body nut. Use a piece long enough to cover the cable connector and
fiber port nut when assembled later.
4 One at a time, carefully insert the MPO fiber cable connectors through the fiber
connection port and into the hub housing. Do not bend or kink fibers.
30
THEN...
splice fiber pigtail of optical fiber input cable to your splice
enclosure and continue to Fiber Optic Connections - Active to
Passive Modules (on page 33).
go to step 2.
OL-29936-01