Cisco GS7000 Installation And Configuration Manual page 11

Ensure the installation site and operating environment is compatible with the

equipment's International Protection (IP) rating specified in the equipment's data
sheet.
Connecting to Utility AC Power
Important: If this equipment is a Class I equipment, it must be grounded.
If this equipment plugs into an outlet, the outlet must be near this equipment,

and must be easily accessible.
Connect this equipment only to the power sources that are identified on the

equipment-rating label, which is normally located close to the power inlet
connector(s).
This equipment may have two power sources. Be sure to disconnect all power

sources before working on this equipment.
If this equipment does not have a main power switch, the power cord connector

serves as the disconnect device.
Always pull on the plug or the connector to disconnect a cable. Never pull on the

cable itself.
Connection to Network Power Sources
Refer to this equipment's specific installation instructions in this manual or in
companion manuals in this series for connection to network ferro-resonant AC
power sources.
AC Power Shunts
AC power shunts may be provided with this equipment.
Important: The power shunts (where provided) must be removed before installing
modules into a powered housing. With the shunts removed, power surge to the
components and RF-connectors is reduced.
CAUTION:
RF connectors and housing seizure assemblies can be damaged if shunts are
not removed from the equipment before installing or removing modules from
the housing.
Grounding (Utility AC Powered Equipment in Pedestals, Service Closets, etc.)
This section provides instructions for verifying that the equipment is properly
grounded.
OL-29936-01
Important Safety Instructions
ix