Troubleshooting Table; Troubleshooting Tips - sunjoe SWJ800E-RM Operator's Manual

Chain Sprocket
Regularly check the condition of the sprocket and replace it
when wear exceeds 0.5 mm (Fig. 22).
Do not mount a new chain with a worn sprocket or vice-versa.
Fig. 22
Troubleshooting

Troubleshooting Tips

Most problems are easy to fix. Consult the troubleshooting
table for common problems and solutions. If you continue
to experience problems or need repairs beyond these minor
adjustments, please call 1-866-SNOWJOE (1-866-766-9563)
for assistance.
m
WARNING!
Always unplug the power cord before
performing any adjustments, maintenance, or repairs to your
pole chain saw.
< 0.5 mm

Troubleshooting Table

Problems Corrective Action
The saw •
Check that you installed the extension cord
motor fails
properly into the pole saw power cord receptacle
to start
and that you plugged the extension cord into a
live 120 V outlet.
•
Make sure that you fully depress and hold the
safety lock button before squeezing the ON/OFF
trigger switch.
The saw
runs, but
•
The chain tension is too tight; re-tension.
the chain
speed is
low
Bar and
•
The chain tension is too tight; re-tension.
chain
running
•
The chain oil tank is empty; refill.
hot and
•
The lubrication holes are plugged; clean them out.
smoking
The saw
motor
•
The chain tension is too tight; re-tension.
runs, but
•
The guide bar or chain is damaged; inspect
the chain
and replace the damaged part.
is not
turning
Daily Checklist, Cleaning
+ Storage
Daily Checklist
To help maintain your electric pole chain saw for optimum
performance, we recommend you complete this checklist prior
to each work session.
m
WARNING!
Do not plug in the power cord until you
have completed all of the daily checks.
• Inspect for any visible damage to the chain, guide bar, or
motor housing.
• Inspect the oil port and guide bar rails and clean them to
remove any debris.
• Check the chain tension.
• Check the chain teeth for sharpness.
• Check the bar and chain oil level; fill with only new chain
oil specifically formulated for chain saws.
NOISES: If you notice anything unusual, such as odd vibrations
or sounds, shut the saw OFF immediately. Remove the power
cord and check the saw for any damage.
14