Advertisement
Preliminary Document
Link2Cell™-19 Unit Orientation & Installation
Link2Cell™ is designed for optimum use as an in-door signal enhancer. The housing is
not weather resistant and the automatic set up procedure assumes sufficient isolation
between antennas. Since the Link2Cell™ has a total of 53 dB active gain and an
isolation of 73 dB must be obtained between the internal donor and the server antenna.
Should adequate isolation not be obtained the unit will automatically reduce its gain until
adequate isolation is obtained for the unit to operate properly. Isolation between the
antennas is reduced by several conditions near or around the antennas, metal or
conductive material, and movement of people near the antennas.
Link2Cell™-19 must be mounted so the Donor antenna is orientated to receive and transmit to
the cell site. The Donor antenna is located on the opposite side of the unit of the LED
indicators of the Link2Cell™-19 with the LED's either at the bottom or the top to keep the
orientation of the Donor antenna correct with respect to the direction of the cell site and which
wall you desire to mount the unit on. 9 VDC input is located on the side of the Link2Cell™-
19 housing shown above.
The Link2Cell™-19 may also sit on top of a book case, cabinet or on the floor as long as
adequate signal is received by the unit to provide the desired coverage enhancement. As was
previously discussed, these cabinets and bookcases should not be metal since this will effect
the performance of the unit.
OR
.
Vertical Mounting Surfaces
TM
Link2Cell
-19
Manual
Confidential
Mounting the Link2Cell™-19
Figure 2
Optional Mounting Configurations
EMS Wireless
OR
Horizontal Mounting Surfaces
Plug Power Converter
into Unit
Plug Power Converter
into 110V Outlet
13
Advertisement
