Advertisement
Preliminary Document
Installation:
Note 1: The user is cautioned that modification or changes to this device not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.
Note 2: Manufacturer's rated composite output power, individual channel power will vary depending on the
number of channels and distance from each cell site being received
Note 3: This device complies with Part 15 of the FCC Rules. Operation is subject to the condition that this
device does not cause harmful interference.
Introduction
Link2Cell™-19 is quick and easy to install, using a set of common tools. This section will
provide the basic steps to performing the installation of Link2Cell™ . Please read
complete instructions before beginning assembly.
Placement of the Unit
Unit must be positioned with the donor antenna facing the direction of the cell site and the
opposite side of the unit with LED indicators facing the intended coverage area. Signal
strength at this location should be adequate to make a call with the subscriber unit for the
SOHO, (Small Office-Home Office) signal enhancer to provide additional coverage and
service in the facility. (See optional mounting configurations in figure 2.)
The signal enhancer provides improved signal performance by amplifying radio frequency
signals being received from the base station and the subscriber unit (mobile phone). The
model Link2Cell™ provides signal enhancement for the entire PCS band only, see the
Link2Cell specifications for details on equipment.
Link2Cell™ is designed to automatically set up its own gain and will improve performance
in most applications as long as a signal is received at the window location. Actual area of
coverage that will be improved will vary depending on the signal level received, and blockage
to the signals in the desired area of coverage. Blockages to RF signals include walls, people,
equipment and furniture, etc. Amount of signal attenuation by each of these blockages will
vary depending upon their size and composition.
If additional area of coverage is required, additional Link2Cell™ units can be cascaded inside
of the facility to provide this. There is a practical limit to the number of signal enhancers that
can be cascaded and provide enhanced system performance. If greater than three total
Link2Cell units are required you should call your system provider for additional solutions
that are available.
TM
Link2Cell
-19
Manual
Confidential
EMS Wireless
11
Advertisement
