Pawl / Carrier - Stihl FS 94 Instruction Manual

7.3

Pawl / Carrier

– Remove the rewind starter,
b 7.2
– Block the piston, b 4.2
1
: Apply tool to hexagon (arrow),
then loosen and unscrew
carrier (1) counterclockwise.
1
2
: Squeeze the retaining lugs on the
pivot (arrows) together and push
out the pawls (1) with torsion
springs (2).
: Remove the torsion springs (2).
– Inspect the torsion springs, pawls
and carrier and replace if
necessary.
Series 4149 Powerhead
Installing
2
: Push the torsion springs (1) onto
the pawls (2) so that the hooks
(arrow) locate against the
pawls (2) as shown.
3
2
: Position the pawls (1) so that the
retaining lugs on the pivots (2)
engage the bores and the
pegs (3) locate in the openings
1
(arrows)
– the pegs (3) limit the range of
movement of the pawls (1).
1
: Push the pawls (1) into the bores
until they snap into place and
locate the ends of the springs
(arrow) against the side of the
carrier (2).
Check operation
– Swing pawls outwards towards
edge of carrier and release – the
1
pawls must spring back
automatically as far as stop.
2
– Reassemble all other parts in the
reverse sequence.
1 1
2
49