Air Guide Shroud - Stihl FS 94 Instruction Manual

5.4.1

Air guide shroud

– Remove the drive tube, b 9.1
– Remove the shroud, b 5.4
– Remove the fan housing, b 4.1
– Remove the ignition module,
b 6.2
– Pull short circuit wire out of guide
in air guide shroud.
1
: Squeeze locking tabs (arrows)
under the retainer (1) together
and push out the manual fuel
pump (2).
: Remove the manual fuel
pump (2) with fuel hoses still
attached and put it to one side.
Series 4149 Powerhead
1
– Unscrew the spark plug.
: Lift the air guide shroud (1) at the
starter side and remove it over
the cylinder.
Installing
2
1
: Position the air guide shroud (1)
at a slight angle and lower it in the
direction of the starter side.
: Line up the air guide shroud (1)
so that it locates on the cylinder
and spacer flange and lines up
with the holes in the cylinder.
– Fit the spark plug and tighten it
down firmly.
– Install the ignition module, b 6.2
1
2
3
: Line up the manual fuel pump (1)
so that the lug (2) points towards
the carburetor.
: Push the manual fuel pump (1)
into the retainer (3) on the air
guide shroud until the locking
tabs (arrows) snap into place
below the retainer (3).
1
: Starting at the flag terminal, push
the short circuit wire (1) into the
guide (arrow) so that it fits snugly
– if necessary, also push the
wires on the throttle cable
retainer fully into the guide.
– Reassemble all other parts in the
reverse sequence.
25