Page 3
Trademarks brushcutter. For further information you Fuel can go to www.stihlusa.com. Fueling Contact your STIHL dealer or the STIHL Fitting the Harness distributor for your area if you do not Balancing the Machine understand any of the instructions in this Starting / Stopping the Engine manual.
Page 4
STIHL dealer or the STIHL illustration. For example: Fuel tank for gasoline distributor for your area for assistance. Loosen the screw (1).
Page 5
Most of these safety precautions and head with flexible plastic blades (i.e., the The use of this machine may be warnings apply to the use of all STIHL PolyCut head.) A "brushcutter" hazardous. If the rotating line or blade trimmer / brushcutters. Different models...
Page 6
WARNING physical conditions that affect blood vessels and blood transport, as well as The ignition system of the STIHL unit high vibration levels and long periods of produces an electromagnetic field of a very low intensity. This field may interfere with some pacemakers.
Page 7
STIHL for operate your power tool and metal blades. Heavy- use with the specific STIHL model are unless wearing goggles duty, nonslip gloves authorized. Although certain or properly fitted protec-...
Page 8
In order to reduce the risk of burns and Fuel other personal injury from escaping gas Your STIHL power tool uses an oil- vapor and fumes, remove the fuel filler gasoline mixture for fuel (see the cap on your power tool carefully so as to chapter on "Fuel"...
Page 9
– a are leaks or damage – risk of fire! Have loose boot may cause arcing that could the machine repaired by a servicing ignite combustible fumes and cause a dealer before using it. fire. FS 94 R...
Page 10
WARNING possible. Your power tool is a one-person The deflector must not be machine. Do not allow other persons in used in combination with the general work area, even when mowing heads. starting. FS 94 R...
Page 11
Working Conditions If you cannot set the correct idle speed, Operate and start your power tool only have your STIHL dealer check your outdoors in a well ventilated area. power tool and make proper Operate it under good visibility and adjustments and repairs.
Page 12
Use of size, may cause respiratory or other a trimmer / brushcutter above ground illnesses. Control dust at the source level or with the cutting attachment FS 94 R...
Page 13
If the behavior STIHL recommends use of the nylon line of the attachment changes during use, heads for such jobs. In addition, be alert WARNING...
Page 14
WARNING and damage to important components muffler maintained by a STIHL servicing (e.g. clutch, polymer housing dealer. Some state or federal laws or To reduce the risk of serious injury, components.) Such damage could,...
Page 15
Uses pre-cut lengths of nylon line. automatically when tapped against the Observe wear indicators. ground (TapAction). STIHL PolyCut mowing head 20-3 WARNING Do not continue using the mowing head Kickout (blade thrust) is if the raised moldings (1) on the base...
Page 16
Never test the ignition system with the properly or if nonapproved replacement spark plug boot removed from the spark parts were used, STIHL may deny plug or with a removed spark plug, since coverage. uncontained sparking may cause a fire.
Page 17
Store the power tool in a dry and high or locked location out of reach of children. Before storing for longer than a few days, always empty the fuel tank. See chapter "Storing the Machine" in the instruction manual. FS 94 R...
Page 18
Cutting attachment Cutting attachments – WARNING Deflector: – For safety reasons only the cutting attachments, deflectors, handles and Handle – Mowing heads harness versions within one line of the Carrying strap – STIHL SuperCut 20-2 STIHL AutoCut 25-2 FS 94 R...
Page 19
12 Deflector: without skirt and blade for metal mowing heads Handle 13 Loop handle 14 Loop handle with 15 Clip (barrier bar) Harnesses 16 Shoulder strap can be used 17 Shoulder strap must be used 18 Full harness can be used FS 94 R...
Page 20
Fit washers (8) on the screws (7) bar (2) as far as stop. and insert the screws in the holes. Fit the square nuts (1) and screw Go to "Securing the Loop Handle". them down as far as stop. Go to "Securing the Loop Handle". FS 94 R...
Need help?
Do you have a question about the FS 94 R and is the answer not in the manual?
Questions and answers