1
: The locking strip (1)
0000 893 5904 must butt against
the cylinder wall (arrow)
– as shown in the illustration.
Disassembling
2
1
: Take out the screws (1).
: Remove the clutch (2) with cover
washers.
1
– Remove the upper cover washer.
: Pull the clutch (1) off the lower
cover washer.
18
Assembling
1
2
: Fold the clutch shoes (1) and
unhook the spring (2).
Position the clutch shoes (1) so that
the markings (arrows) are visible.
The spring (2) must be hooked into
the back of the clutch shoes (1).
– Reassemble the clutch shoes in
1
the reverse sequence.
2
3
1
4
: Fit the washers (1) over the
sleeves.
: Position the clutch (2) so that the
marks (arrows) face up.
: Push clutch (2) onto sleeves (3)
of lower cover washer (4).
1
1
: Fit upper cover washer (1) so that
the recesses (arrows) face up
and the holes are in alignment.
Installing
2
1
3
: Position clutch (1) with cover
washers on tapped holes
3
(arrows) in flywheel (2).
: Insert and tighten down the
screws (3) firmly.
1
– Remove the locking strip from the
cylinder.
– Install the fan housing, b 4.1
– Reassemble all other parts in the
reverse sequence.
Series 4149 Powerhead
3