Configuring Wps (Wi-Fi Protected Setup) - RocketFish RF-HTN104 User Manual

Configuring WPS (Wi-Fi Protected Setup)

Wi-Fi Protected Setup (WPS) System is a simplified method for securing your wireless network during the initial setup and the process of adding a new device to the
network. The Wi-Fi Alliance (WFA) has certified it across different products and manufacturers. There are two simple methods to securely add a device to your network via
WPS; The Push Button Configuration (PBC) method and the Personal Identification Number (PIN) Code method. Both of these WPS methods greatly reduce the time it takes
to get a new device on your network while using WPA2 encryption.
To add a new device using the PBC method:
1. Press the Virtual Button on the Wi-Fi Protected Setup Page or hold down
the CONNECT button located on the front of your wireless router device
for approximately 3 seconds. The RocketFish router will attempt to find
other devices that support WPS within range.
2. Go to your wireless client and hold down the CONNECT button on the
front of your wireless client device for approximately 3 seconds. Your
client should find the signal of the router and they should connect within
2 minutes.
To add a new device using the PIN Code method:
1. Acquire the PIN number for your wireless client device.
Wi-Fi Invite Home Hub, the PIN number is printed on the bottom of the
device.
2. On the RocketFish router, enter the PIN into the field labeled PIN Code
and click Connect. On the Wi-Fi Invite Hub, press the CONNECT button on
the front panel to confirm the connection. On other brands of hub, start
the WPS tool and confirm theconnection with the CONNECT
two devices will connect within 2
On the RocketFish
button.The
minutes.
刪除: Usually a device will have a 刪除 刪除 刪除
PIN Code printed on the device
itself somewhere.
格 格 格 格 式化 式化: : : : 字型: 非粗體
式化 式化
格 格 格 格 式化 式化: : : : 字型: 非粗體
式化 式化
刪除 刪除: should connect within 2 刪除 刪除
minutes.
54