Table of Contents
Advertisement
Free Speed
Maximum Working Pressure
Air Inlet
Recommended Hose Size
Keyless Chuck
Air Consumption @ 90 PSI
Accessories Required
IMPORTANT: Line pressure or hose inside diameter should be increased to compensate
for unusually long air hoses (over 25 feet). Minimum hose diameter should be 3/8" I.D.
and fittings should have 1/4" NPT thread.
Assemble Stabilizer Handle
1.
Slide stabilizer handle onto tool, rotate to desired position and tighten.
Before each use:
G
Drain water from air compressor tank and condensation from air lines. See air
compressor's operators manual.
G
Lubricate tool, see "Maintenance" section in this manual.
G
Open the keyless chuck (A), no tools are required.
G
Insert and center drill bit in the jaws (B) as you close chuck.
NOTE: An off centered drill bit will wobble and could break.
G
Connect tool to air hose of recommended size. NOTE: The use
of a quick connect set makes connecting easier.
IMPORTANT: The use of air filters and air line lubricators is
recommended.
SPECIFICATIONS
OPERATION
Stabilizer
Trigger
Handle
Disconnect the tool from the air supply before lubricating or
changing drill bits.
600 RPM
90 PSI
1/4" NPT
3/8" I.D.
1/2"
6.0 SCFM
ASSEMBLY
Chuck
5- ENG
Reverse
and
Forward
Lever
Air Inlet
B
A
D22722
Advertisement
Table of Contents
