Alvarion WBSAC-2450 Quick Installation Manual page 7

Please ensure that you read and understand the following safety information. Ensure that you carefully
read and follow all instructions in this manual, and heed all warnings.
Warnings It is illegal to modify the construction of this product. Modifying the operating frequency or
enhancing the transmit output power through the use of external amplifiers or other
equipment is specifically disallowed by the "Telecommunications Act".
There is a risk of personal injury or death if the WBSac antennas are close to electric power
lines.
By nature of the outdoor installation, you may be exposed to hazardous environments and
high voltage. Use extreme caution when installing the system.
Servicing is required when the apparatus has been damaged in any way. All servicing should
be referred to qualified service personnel only.
The base station must be properly grounded.
Do not open the unit – risk of electric shock.
Warnings
Any change or modification not expressly described in this manual or approved by the
manufacturer could void your authority to operate this equipment.
WBSac should only be installed using the antennas that were provided as part of the original
package.
A minimum distance of 40cm should be kept from the WBSac antenna when the system is in
operation.
To maintain Overvoltage (Installation) Category II, install a suitable surge suppressor device
in the branch circuit to limit expected transients to Overvoltage Category II values. The limits
are based on IEC60664 and are also located in Table 2H of UL60950 (for mains 110V, the
transient rating is 1500V).
For further information, please contact Alvarion Technical Support at:
Page | 7
Safety instructions and information
support@alvarion.com
DOC00182-00 rev-B