Alvarion WBSAC-2450 Quick Installation Manual page 6

Connecting Power and DATA to the WBSac base station
Warning: Before applying power to the device,
ensure that all the antennas are connected
1. Connect one end of the Ethernet cable into the LAN
port (PoE) of the Access Point (see sealing gland
installation chapter bellow) and the other end to the
"PoE" port on the PoE injector.
2. Connect the PoE injector in to an electrical outlet
using the supplied cable.
3. Connect the second Ethernet cable into the "LAN"
port of the PoE injector and the other end to the
Ethernet port on the network device.
Sealing gland installation
1. Unscrew sealing gland nut, pull out the rubber bushing and thread Ethernet cable through the
sealing plug components.
2. Insert RJ45 plug into POE port on the device, check that sealing washer is in place and install
sealing gland base. Tighten sealing gland base to ensure proper sealing.
3. Slide the rubber bushing into sealing gland base
4. Close the sealing gland nut and tighten it until the rubber bushing is compressed, making
Ethernet cable sealed.
For further information, please contact Alvarion Technical Support at:
Page | 6
support@alvarion.com
DOC00182-00 rev-B