Binding Service Instances To Vpls Instances - HPE 5820X Series Configuration Manual

Binding service instances to VPLS instances

Network requirements
CE 1 and CE 2 are connected to PE 1 and PE 2 through VLANs.
On PE 1 and PE 2, perform the following configuration:
•
Configure VPLS instance aaa to use LDP (Martini mode) and VPLS instance bbb to use BGP
(Kompella mode), and configure the AS number as 100.
•
Configure service instance 1000 to match packets that are received on GigabitEthernet 1/0/1
and carry the VLAN tag of 100. Bind service instance 1000 to VPLS instance aaa.
•
Configure service instance 2000 to match packets that are received on GigabitEthernet 1/0/1
and carry VLAN tag of 200. Bind service instance 2000 to VPLS instance bbb.
Figure 45 Network diagram
GE1/0/ 1
CE 1
Configuration procedure
Configure PE 1:
1.
<Sysname> system-view
[Sysname] sysname PE1
[PE1] interface loopback 0
[PE1-LoopBack0] ip address 1.1.1.9 32
[PE1-LoopBack0] quit
# Configure the LSR ID and enable MPLS globally.
[PE1] mpls lsr-id 1.1.1.9
[PE1] mpls
[PE1-mpls] quit
# Enable L2VPN and MPLS L2VPN.
[PE1] l2vpn
[PE1-l2vpn] mpls l2vpn
[PE1-l2vpn] quit
# Enable LDP globally.
[PE1] mpls ldp
[PE1-mpls-ldp] quit
# Configure PE 1 to establish an LDP remote session with PE 2.
[PE1] mpls ldp remote-peer 1
[PE1-mpls-ldp-remote-1] remote-ip 3.3.3.9
[PE1-mpls-ldp-remote-1] quit
# Configure the interface connected to the P device and enable LDP on the interface.
Loop 0
1.1 .1. 9/ 24
Vlan-int 2
23. 1.1 .1/ 24 23 .1 .1. 2/ 24
PE 1
Loop 0
2.2 .2. 9/ 24
Vlan -int 2 Vlan-int 3
26. 2.2 .2/ 24
P
185
Loop
3 .3. 3. 9/ 24
Vlan -int 3
26. 2. 2. 1/24
GE1/0/1
PE 2
CE 2