Section 1; Setting Up The Unit; Select A Place For The Unit - burroughs SmartSource Edge Installation And Operation Manual

Section 1

Setting Up the Unit

Select a Place for the Unit


For indoor use only

Place on a flat, stable surface

Clearances required :





Close to the host PC

Close to a power outlet

Allow for adequate ventilation

Away from water/moisture/high humidity, heat/direct sunlight, and dust





Notes:

The unit draws 40 watts (maximum) from a 100 to 240 VAC, 50/60 Hz outlet. The unit
draws 1.5 amps (maximum) from the included 24 VDC power supply.

Each unit must be operated with Burroughs power adaptor 75-0860-917 and no other.
The SmartSource Edge may be susceptible to "burst" or "electrical fast transient" (EFT)
noise entering the unit through the power cord. These types of noise signals are caused
by large electrical equipment (such as heating and cooling units) connected to nearby
electrical outlets.
functioning. The operator must restart the SmartSource Edge and its application(s).
If this occurs,

Plug the SmartSource Edge Power Supply into an electrical outlet on a different branch of
the power distribution system where large electrical equipment is not connected to nearby
outlets.

Plug the SmartSource Edge Power Supply into a line conditioning device or an
uninterruptible power source.
8224 2462-001
−8in (20.3cm)
At the front, to load and remove documents.
−7in (17.8cm)
At the rear, to load and remove cards and documents,
connecting the power cord (from the power supply), and to connecting the USB
cable.
−4in (10.2cm)
Above the unit, to remove covers and to access the track.
−12in (30.5cm) Away from any CRT monitors to reduce interference with the
reader inside the unit.
Operating temperature: 10 to 40ºC(50 to 104ºF)
Storage temperature:
Shipping temperature: -40 to 65ºC (-40 to 149ºF)
Operating humidity:
Storage humidity:
Burst or EFT noise may cause the SmartSource Edge to stop
-20 to 60ºC (-4 to 140ºF)
20 to 80 percent (non-condensing)
5 to 95 percent (non-condensing)
Caution
5