Table of Contents
Advertisement
Transmitter Programming
1.
Turn the ignition ON.
2.
Press and hold the valet/override button located on the antenna.
3.
Within 10 seconds the LED's will begin to flash.
4.
Press 1 button of each transmitter you wish to program, the LED's will
flash to confirm each transmitter.
5.
Turn the ignition OFF
NOTE: This system has 1 button programming which programs all channels of the
system.
NOTE: The system will hold up to 4 transmitters in memory, programming a 5th
transmitter will erase the oldest transmitter in memory.
Replacing Remote Control Batteries
1 Way Remote Control, CAT1:
The battery (model CR2032) inside each remote control should last approximately 1
year under normal use. When the battery becomes weak you will notice the remote
control range (the distance from the vehicle the remote control will work) deteriorate
and the small LED on the remote control will dim. To replace the battery in the remote
control:
1.
Unsnap and disassemble the halves of the remote control.
2.
Remove the old battery, observing the +/- symbols on the battery
and replace with new CR2032 battery.
3.
Reassemble the halves of the remote control.
4.
Test operation of the remote control.
6
2017 Voxx Electronics Corporation. All rights reserved.
Advertisement
Table of Contents
