Before Use - Belling BE807 Installation And User Instructions Manual

Before Use

• Before connecting the appliance to the mains supply, let it stand for
about 2 hours, to reduce possibilities of malfunctions in the cooling
system due to transport and handling.
• Clean the appliance thoroughly, especially inside (See Cleaning and
Maintenance).
We Care for the Environment
• Our products use environmentally friendly packaging, which can be
either recycled or disposed of in an environmentally friendly manner.
To this end, individual packaging materials are clearly marked.
• These instructions are printed either on recycled paper or chlorine
free bleached paper.
• To minimise the risk of injury to children please dispose of your
product carefully and safely. (See section on Disposing of your
appliance).
Tips for Energy Savings
• Try not to open the door too often, and close it as soon as possible.
• Every now and then check if the appliance is sufficiently ventilated
(adequate air circulation behind the appliance).
• Set thermostat to lower settings as soon as possible (depends on the
amount of food loaded, ambient temperature etc).
• Never use continuous operation unless required; switch the operation
mode selection switch to the setting for automatic operation as soon as
possible.
• Before loading the appliance with packages of fresh foods, make sure
they are cooled to ambient temperature. (except for soup)
• Ice and frost layers increase energy consumption, clean the appliance
as soon as the layer is 3-5 mm thick.
• If the gasket is damaged or if it turns out that the sealing is poor, the
energy consumption is substantially higher. To restore efficiency,
replace the gasket.
• The condenser on the rear wall should be always clean, free of dust or
any impurities.
10 Instructions for Use