Reversing The Door Opening - Belling BE807 Installation And User Instructions Manual

Reversing the door opening

If you find the door opening direction of your appliance inconvenient,
you can reverse it. The necessary holes on the opposite side of the
appliance cabinet have been made in the factory and plugged.
• Remove the top hinge cover of the refrigerator door. Remove the
door by unscrewing the hinge (the door is supported only by the
bottom hinge) and remove the hinge washer.
• Unscrew the top fixing strip, move it to the opposite side of the
appliance and fasten it.
• Unscrew the bottom hinge and washer of the freezer door and
remove the lower door.
• Unscrew the top hinge of the freezer door and the bottom hinge of
the refrigerator door.
• Remove the corner caps from the door and reposition them (instead
of the corner cap with a hole insert the one without it, and vice
versa).
• Take off the washer from the bottom hinge of the freezer door (by
turning it in clockwise), pull out the bottom hinge pivot and fit into
opposite side.
• Put the freezer door on the bottom hinge.
• Turn the bottom hinge of the refrigerator door by 180°, insert the
hinge and the washer into the hole of the corner cap on the freezer
door and fasten it. Use the same procedure for the top hinge of the
freezer door and screw it on the opposite side of the upper door. Put
the washer and the upper door on the hinge.
• Screw the top hinge of the refrigerator door and replace the cover.
• Reposition the slide guides on the opposite sides of both doors.
• Plug the remaining holes with decorative caps.
• After you have reversed the door, check if the magnetic gasket seals
correctly. It must not be creased and must seal all around the door.
4 Instructions for Use